Video: Controller Management - Config Mode for Debugging

Support
Support
Share
Config Mode for Debugging

Test hardware interface components via the serial monitor. In configd mode your controller will cycle through a program for visual inspection of hardware interface components. In config and configd mode your controller will not try to connect to hardware devices.

Controller Management for UniSketch
Effective Ways of Configuration
In this training video we demonstrate how to configure your controller in two...
Config Mode for Debugging
Test hardware interface components via the serial monitor. In configd mode yo...
Calibration
Watch how you can calibrate a analog component such as a T-bar. This is relev...
Actions and HWC Types
A introduction to Device Cores and what is hidden behind each action for our ...
The Serial Monitor
The Serial Monitor is a handy tool for checking the status of your UniSketch ...
Status LED and Configuration Mode
The status LED can be the first place to look if you want to know connection ...
Upgrading Firmware
Please Notice: Using the "Check for updates" will only work on UniSketch base...